AXIS ONE
Start with your problem
If something is already wrong, start here. Each route answers the question in the words people actually use.
There is a damp patch and I don't know where it's from
Water shows you where it came out, never where it went in. Read the leak by timing and location before anyone quotes you.
Explore guide → ELEVATIONMy exterior paint is peeling after two monsoons
Understand why exterior coatings fail, why walls need to breathe, and how silicone-resin protection changes the approach.
Explore guide → BASEMENTMy basement is leaking
The leak is not always the real failure. See the systems, stages and waterproofing approach used for underground structures.
Explore guide → TERRACEMy terrace was done with coba and still leaks
Coba builds the fall and buffers the heat. It is not itself the waterproofing barrier.
Explore guide → JOINTSIt keeps failing at the same crack or joint
A joint is a movement detail, not a surface to simply coat across. Start with the joint detail and system.
Explore guide → FAILUREThis has been treated before and failed again
Review the failure modes behind repeat waterproofing problems and the difference between diagnosis and guesswork.
Explore guide →AXIS TWO
By part of the building
Choose the building part you are dealing with. One subject can lead to more than one route — that is intentional.
Terrace & roof
Brick bat coba, falls, the flood test, and what must sit under the fill
Read / explore →7 Terrace Waterproofing Methods Compared
Cementitious, PU, membrane, elastomeric, integral or engineered — see where each method works, where it fails, and how to pick the right one for your terrace.
Read / explore →Raft & foundation slab
Pre-applied membrane over the PCC, before casting — positive-side protection that is only available once
Read / explore →Basement & underground
Three-stage waterproofing thinking and the systems used for underground structures
Read / explore →Elevation & external walls
Breathability, water repellency and why conventional exterior paint can fail
Read / explore →Podiums, terrace gardens & pools
Waterproofing considerations for areas that become difficult to access after construction
Read / explore →Expansion joints & movement gaps
Where the building is designed to move — the systems that bridge it, and what belongs in an exposed joint versus a buried one
Read / explore →Bathrooms & sunken slabs
The core cut, sleeves and wet-area sequencing
Read / explore →Water tanks & sumps
Keeping stored water protected with an appropriate waterproofing system
Read / explore →The structure itself
Concrete is not waterproof, and the structure keeps moving
Read / explore →AXIS THREE
Before you spend money
Understand the variables before comparing quotations, warranties or schedules.
What waterproofing actually costs per sq ft
Use the supplied cost-focused waterproofing article to understand cost drivers rather than relying on a generic rate card.
Explore guide → WARRANTYRead the warranty before you read the quotation
The three dates, limits and written conditions matter before you compare quotations.
Explore guide → TIMINGPlan the waterproofing window before the next layer covers it
Use the relevant building-part page to understand sequencing and why access after finishing changes the repair equation.
Explore guide → COMMITTEESHow a society committee should compare three quotes
Per flat, per year — and what belongs in the work order, not just the quotation. Written for committees that have to defend the decision at the AGM.
Explore guide →